Design And Fabrication Of A Bench Mounted Closed Loop Wind Tunnel
A Bench-mountedclosed loop wind tunnel has been designed and fabricated to study the air flow characteristics and its effects on different models at different flow conditions. Thefabricated wind tunnel is sub-sonic nature with operating velocity from 0 to 18 m/s. The wind tunnel could be used to car...
Збережено в:
| Автори: | , , , , , |
|---|---|
| Формат: | Стаття |
| Мова: | Англійська |
| Опубліковано: |
R&D Wing, MIST
2015
|
| Предмети: | |
| Онлайн доступ: | http://hdl.handle.net/123456789/225 |
| Теги: |
Немає тегів, Будьте першим, хто поставить тег для цього запису!
|
| Резюме: | A Bench-mountedclosed loop wind tunnel has been designed and fabricated to study the air flow characteristics and its effects on different models at different flow conditions. Thefabricated wind tunnel is sub-sonic nature with operating velocity from 0 to 18 m/s. The wind tunnel could be used to carry out research on different model for laminar and turbulent flow conditions .The wind tunnel is powered by two similar co-rotating axial flow fans and the air velocity could be varied by varying the fan speed. The wind tunnel consists of a test section, bell mouth nozzle, bends, guide vanes and fan section. An ATMega16 microcontroller based Data Acquisition Card (DAQ)has been incorporatedhere to measurepressure through pressure sensors. Steady state flow condition could be attained from the wind tunnel within short period of time to easily explain the flow parameterswhile carrying out the experiments. |
|---|