STUDY OF TWO PHASE LOOP THERMOSYPHON BY USING VARIOUS EVAPORATOR SURFACE GEOMETRIES WITH DIFFERENT WORKING FLUIDS /

Tallennettuna:

Bibliografiset tiedot
Päätekijä:	Sarker, Md. Alamin
Yhteisötekijä:	Supervised by Lt. Col. Mustafa Kamal (Instructor, Dept. of Mechanical Engineering.)
Muut tekijät:	Md. Mehadi hasan, Ruma Akhter
Aineistotyyppi:	Kirja
Kieli:	englanti
Julkaistu:	Dhaka : ME DEPT MIST , c 2011
Aiheet:	Thesis Paper of ME in B.Sc Prog. Mechanical Engineering.
Tagit:	Lisää tagi Ei tageja, Lisää ensimmäinen tagi!

Samankaltaisia teoksia: STUDY OF TWO PHASE LOOP THERMOSYPHON BY USING VARIOUS EVAPORATOR SURFACE GEOMETRIES WITH DIFFERENT WORKING FLUIDS /

Pikavilkaisu
STUDY ON VARIATION OF EVAPORATION WITH VARIOUS CLIMATIC PARAMETERS AND APPROPRIATENESS OF DIFFERENT METHODS IN PREDICTING EVAPORATION /
Pikavilkaisu
Droplet Evaporation and Leidenfrost Phenomena on Metallic Surfaces
Pikavilkaisu
LESSILE DROP EVAPORATION AND LEIDEN FROST PHENOMENON /
Pikavilkaisu
Boiling Heat Transfer and Two-Phase Flow /
Pikavilkaisu
COMPREHENSIVE DESIGN AND A PERFORMANCE TEST OF AN EVAPORATIVE COOLER /
Pikavilkaisu
PERFORMANCE TEST OF AN REFRIGERATION SYSTEMS EVAPORATOR SECTION WITH HEAT PIPE /
Pikavilkaisu
DESIGN AND FABRICATION OF MODEL SURFACE TO SURFACE MISSILE LAUNCHING SYSTEM /
Pikavilkaisu
THE EFFECT OF ETHANOL AS WORKING FLUID ON THE PERFORMANCE OF DIFFERENT TYPES OF CLOSED LOOP PULSATING HEAT PIPE / Mehrin Chowdhury, Sanjida parveen, Nawshad Arslan Islam, Sayed Mahmud Mufti.
Pikavilkaisu
DESIGN AND PERFORMANCE ANALYSIS OF AN ENHANCED SUBMERGED EVAPORATOR FOR MID-RANGE (5-10) AIR COOLED CHILLER SYSTEMS /
Pikavilkaisu
INVESTIGATION ON LIFT AND DRAG COEFFICIENTS OF PROJECTILES AT VARIOUS ANGLES OF ATTACK /
Pikavilkaisu
INVESTIGATION ON SURFACE ROUGHNESS AND TOOL WEAR FOR DIFFERENT DRILL BIT GEOMETRY IN DRILLING OPERATION ON MILD STEEL /
Pikavilkaisu
EXPERIMENTAL AND NUMERICAL EVALUATION OF THE THERMO-HYDRAULIC PERFORMANCE OF WINGED CYLINDRICAL PIN-FIN HEAT SINK WITH RELATIVE ASSESSMENT OF DIFFERENT MODIFIED PIN-FIN GEOMETRIES /
Pikavilkaisu
Design of a Phase Locked Loop by using 50nm CMOS Technology
Pikavilkaisu
EXPERIMENTAL INVESTIGATION ON THE CHARACTERISTICS OF A CLOSED LOOP PULSATING HEAT PIPE (CLPHP) FOR DIFFERENT FLUIDS
Pikavilkaisu
DESIGN AND FABRICATION OF A MODEL SURFACE TO SURFACE MISSILE WITH MOTION CONTROL SYSTEM RUN BY COST-EFFECTIVE SOLID PROPELLANT /
Pikavilkaisu
NUMERICAL ANALYSIS OF FLOW AND HEAT TRANSFER CHARACTERISTICS BETWEEN TWO PARALLEL PLANETS WITH CONTRACTION /
Pikavilkaisu
EXPERIMENTAL STUDY ON THE PERFORMANCE OF MEDICAL INDUCED DRAFT COOKING TOWER USING DIFFERENT QUALITY OF CIRCULATING FLUIDS /
Pikavilkaisu
PERFORMANCE ANALYSIS OF A CLOSED-LOOP PULSATING HEAT PIPE FOR ENHANCEMENT OF PHOTOVOLTAIC CELL EFFICIENCY /
Pikavilkaisu
EXPERIMENTAL STUDY ON SOLAR DRYER BY INTEGRATING PHASE CHANGE MATERIALS (PCM) FOR DRYING CHIPS /
Pikavilkaisu
COMPARISON OF AERODYNAMIC PROPERTIES OF TRADITIONAL TURBINE BLADES AND CLOSED-LOOP TURBINE BLADES FOR WIND ENERGY EXTRACTION /
Pikavilkaisu
DESIGN IMPROVENMENT AND DEVELOPMENT OF A CLOSED LOOP SOLAR HEAT COLLECTOR WITH DATA ACQUISITION SYSTEM /
Pikavilkaisu
INVESTIGATION OF PARAMETRIC SURFACE CAVITIES ON THE TRANSONIC AERODYNAMIC PERFORMANCE OF THE RAE 2822 AIRFOIL /
Pikavilkaisu
EXPERIMENTAL INVESTIGATION ON THE EFFECT OF INSERTED WIRE ON THE CHARACTERISTICS OF A CLOSED LOOP PULSATING HEAT PIPE (CLPHP) /
Pikavilkaisu
Experimental Investigation on Droplet Evaporation and Leidenfrost Phenomenon