Ítems similars: DESIGN, CONSTRUCTION AND PERFORMANCE CHECKING OF A LOW COST & LIGHTER BLADE ANTENNA /
- DESIGN , CONSTRUCTION AND PERFORMANCE CHECKING OF BLADE ANTENNA /
- DESIGN AND DEVELOPMENT OF A BLADE ANTENNA FOR AIRCRAFT NAVIGATION AND COMMUNICATION /
- PERFORMANCE ANALYSIS OF CENTRIFUGAL COMPRESSOR WITH AND WITHOUT SPLITTER BLADES /
- SURFACE MODIFICATION OF NACA 4418 AIRFOIL WITH DIFFERENT SHAPED DIMPLES AND AERODYNAMIC PERFORMANCE ANALYSIS /
- STUDY ON DESIGNING OF TRANSMISSION SECTION OF A LOW COST PHASED ARRAY RADAR SYSTEM /
- ANALYSIS OF RADAR CROSS SECTION (RCS) OF DIFFERENT SHAPE OF TARGETS USING MICROSTRIP ANTENNA IN ORDER TO DESIGN & FABRICATE A PROTOTYPE OF LOW COST PHASED ARRAY RADAR /
Tema: Aeronautical Engineering
- ACTIVE CONTROL OF FLOW PAST OVER NACA 0021 THROUGH LEADING EDGE MOMENTUM INJECTION USING ROTATING CYLINDER: A COMPARATIVE INVESTINGATION BETWEEN NUMERICAL & EXPERIMENTAL ANALYSIS/
- A COMPREHENSIVE STUDY OF FLOW THROUGH CIRCULAR PIPE /
- MODELING AND SIMULATION OF LONGITUDINAL AUTOPILOT FOR GENERAL AVIATION AIRCRAFT /
- DEVELOPMENT OF A PHASED OUT AIRCRAFT AS EDUCATIONAL AID /
- MACHINABILITY OF POLYMER MATRIX COMPOSITES (PMC)-A REVIEW OF CURRENT STATUS AND FUTURE PROSPECTS /
- ANALYSIS AND INSTALLATION OF AVIONICS SYSTEM IN A SMALL UNMANNED AIRCRAFT /
Tema: This Thesis Paper of AE in B.Sc. Program.
- DESIGN, ANALYSIS AND OPTIMIZATION OF A SMALL UNMANNED AIRCRAFT /
- ANALYSIS OF DESIGN FLAWS IN AN UNMANNED AERIAL VEHICLE (UAV) TARGET DRONE AND FABRICATION, CFD ANALYSIS AND TUNNEL TESTING OF A 3D MODEL POST AMENDMENT /
- DESIGN AND FABRICATION OF A TARGET DRONE /
- SHAPE OPTIMIZATION OF GURNEY FLAP ON AIRFOIL /
- FABRICATION OF AL-6063 METAL MATRIX HYBRID COMPOSITE REINFORCED WITH SIC NANOPARTICALS BY STRI CASTING /
- DESIGN & DEVELOPMENT OF A SOFTWARE TOOL FOR ANALYSIS OF THE CHARACTERISTICS OF INSTRUMENTED RECTILINEAR OPEN LOOP CONTROL SYSTEM /