-
Machining and CNC technology /
-
DESIGNING, DEVELOPMENT & FABRICATION OF SPRING MASS DAMPER SYSTEM /
-
STUDY OF FAULT TOLERANCE OF A FLIGHT CONTROL SYSTEM ACTUATOR IN FLY-BY-WIRE SYSTEM /
-
DESIGN AND FABRICATION ON VACUUM ASSISTED INFUSIUN MOLDING SETUP FOR FABRICATION OF FLAT AND CURVED COMPOSITE PANELS /
-
"DESIGN,FABRICATION AND DEVELOPMENT OF AN UNMANNED AERIAL VEHICLE CAPABLE OF DELIVERING MISSION PAYLOAD"
-
DESIGN AND FABRICATION OF A TARGET DRONE /
-
DESIGN, FABRICATION,AND FLIGHT TESTING OF GHOST WING "GW-1" MAV /
-
DESIGN AND FABRICATION OF LUNAR DUST EXCAVATOR ROBOT /
-
DESIGN AND FABRICATION OF AUTOMATIC FUEL TRANSFER SYSTEM OF AN AIRCRAFT /
-
DESIGN OF FUEL MANAGEMENT SYSTEM TO ADDRESS FAILURE IN AUTOMATIC FUEL TRANSFER SEQUENCE AND FABRICATE A REDUNDANCY SYSTEM /
-
DESIGN,ANALYSIS AND FABRICATION OF A FULLY ARTICULATED HELICOPTER MAIN ROTOR SYSTEM /
-
DESIGN AND FABRICATION OF AN AUTOPILOT MODEL TO INCORPORATE AUTOMATIC CONTROL OF THE MOMENT OF THE CONTROL SURFACES /
-
FABRICATION OF AL-6063 METAL MATRIX HYBRID COMPOSITE REINFORCED WITH SIC NANOPARTICALS BY STRI CASTING /
-
DEVELOPMENT OF AL-BASED METAL MATRIX COMPOSITES REINFORCED WITH HYBRID NANO PARTICLES AND ITS MACHINABILITY TEST /
-
DESIGN AND FABRICATION OF A MICRO UAV WITH DEVELOPMENT OF ITS STRUCTURE, PROPULSION AND CONTROL SYSTEM / Md. Tauhid Rahman Evan, Mir Md. Al Kahman Tamal, Md. Jamal Mian
-
Fabrication and Property Investigation of SiC Reinforced Aluminium based Metal Matrix Composite for Aerospace materials /
-
DESIGN AND FABRICATION OF A FIXED-WING (UNMANNED AERIAL VEHICLE) TARGET DRONE FOR TESTING OF AIR DEFENSE SYSTEM /
-
DESIGN AND FABRICATION OF TSVU (TRI COPTER SHAPED VTOL UAV) /
-
DESIGN AND FABRICATION OF THE FUSELAGE OF A RADIO CONTROLLED AERIAL VEHICLE /
-
DESIGN DEVELOPMENT OF WEAPON CONTROL SYSTEM TO ACCOMMODATE GUIDED AMMUNITION AND ROCKET POD /
-
DESIGN AND FABRICATION OF AIRFRAME STRUCTURE & CONTROLS OF UAV / Md. Fazlay Robbey, Md. Mukit Hasan, Saiful Islam .
-
DESIGN AND FABRICATION OF AN UNMANNED AERIAL VEHICLE EATABLE OF DELIVERING MISSION PAYLOAD /
-
DESIGN AND FABRICATION OF A GAS GENERATOR USING AN AUTO MOBILE TURBOCHARGER /
-
DESIGN AND DEVELOPMENT OF A COMBIND TORSION AND BENDING TEST SETUP FOR EVALUATING MECHANICAL PROPERTIES OF MATERIALS /