Ítems similars: DESIGN AND FABRICATION OF A REMOTELY OPERATED UNMANNED COMBAT VEHICLE /
- POTENTIAL APPLICATION OF GRAPHENE ON COMBAT VEST ARMOUR /
- STRUCTURAL DESIGN ANALYSIS AND FLIGHT TEST OF AN UNMANNED AERIAL VEHICLE (UAV) HAVING AEROFOIL SHAPED FUSELAGE /
- DESIGN AND FABRICATION OF A BIONIC HAND /
- DESIGN AND FABRICATION OF VAPOR ABSORPTION REFRIGERATION SYSTEM FOR VEHICLE CABIN COOLING UTILIZING EXHAUST HEAT /
- DESIGN AND FABRICATION OF A QUADCOPTER WITH FIXED WING /
- DESIGN AND FABRICATION OF A 3D CONCRETE PRINTER /
Tema: Mechanical Engineering.
- EVALUATION OF CHANGE IN OXIDATION RATE OF ETHYLENE GLYCOL-WATER SOLUTION USING JUTE LEAF POWDER/
- HYBRID PASSIVE-ACTIVE COOLING STRATEGY FOR ELECTRIC VEHICLE BATTERY PACKS: AN EXPERIMENTAL APPROACH /
- EXPERIMENTAL STUDY ON SOLAR DRYER BY INTEGRATING PHASE CHANGE MATERIALS (PCM) FOR DRYING CHIPS /
- INVESTIGATION OF PARAMETRIC SURFACE CAVITIES ON THE TRANSONIC AERODYNAMIC PERFORMANCE OF THE RAE 2822 AIRFOIL /
- EXPERIMENTAL PERFORMANCE ENHANCEMENT OF A CONVENTIONAL AIR CONDITIONING SYSTEM USING PRE-COOLING TECHNIQUE IN CONDENSER SECTION /
- MECHANICAL PERFORMANCE OF HYBRID GRAPHENE- BASALT FIBER COMPOSITES FOR LIGHTWEIGHT SPAR CAP APPLICATIONS IN WIND TURBINES /
Tema: This Thesis Paper of ME in B.Sc. Program.
- DEVELOP A CUT VIEW MODEL OF JET ENGINE /
- STRUCTURAL DESIGN ANALYSIS AND FLIGHT TEST OF AN UNMANNED AERIAL VEHICLE (UAV) HAVING AEROFOIL SHAPED FUSELAGE /
- DETERMINATION OF CRITICAL SPEED OF A SHAFT /
- DESIGN AND FABRICATION OF MODEL SURFACE TO SURFACE MISSILE LAUNCHING SYSTEM /
- DESIGN AND FABRICATION OF A MODEL SURFACE TO SURFACE MISSILE WITH MOTION CONTROL SYSTEM RUN BY COST-EFFECTIVE SOLID PROPELLANT /
- DESIGN AND FABRICATION OF A REMOTELY OPERATED UNMANNED COMBAT VEHICLE /