Նմանատիպ նյութեր: CONSTRUCTION AND MODELLING OF AN INVERTED PENDULUM ON A CART /
- MODELING AND SIMULATION OF LONGITUDINAL AUTOPILOT FOR GENERAL AVIATION AIRCRAFT /
- FLOW CHARACTERISTICS AND HEAT TRANSFER CHARACTERISTICS OVER NACA 4415 AIRFOIL
- INVESTIGATION OF THE EFFECT OF DIFFERENT AIRFOIL SHAPED FUSELAGE ON THE PERFORMANCE OF AN UNMANNED AIR VEHICLE /
- DESIGN, CONSTRUCTION AND PERFORMANCE CHECKING OF A LOW COST & LIGHTER BLADE ANTENNA /
- CONSTRUCTION AND STUDY OF VALUELESS PURSUIT ENGINE /
- LARGE DEFECTION ANALYSIS OF AN AIRCRAFT WING WITH ELLIPTICAL LIFT DISTRIBUTION AT DIFFERENT FLIGHT CONDITION /
Խորագիր: Aeronautical Engineering
- ACTIVE CONTROL OF FLOW PAST OVER NACA 0021 THROUGH LEADING EDGE MOMENTUM INJECTION USING ROTATING CYLINDER: A COMPARATIVE INVESTINGATION BETWEEN NUMERICAL & EXPERIMENTAL ANALYSIS/
- DESIGN AND DEVELOPMENT OF A BLADE ANTENNA FOR AIRCRAFT NAVIGATION AND COMMUNICATION /
- COMPARATIVE STUDY OF SWIRL FLOW & JET FLOW /
- COMPARATIVE STUDY OF AIRCRAFT APPROACH AND LANDING PERFORMANCE USING ILS, MLS AND GLS /
- MANUFACTURE AND MISSION PERFORMANCE ANALYSIS OF SMALL UNMANNED AIRCRAFT’ /
- A COMPARISON OF EXPERIMENTAL WITH SIMULATION EFFECTIVE OF NACA 0012 AIRFOIL WITH BARE /
Խորագիր: This Thesis Paper of AE in B.Sc. Program.
- DESIGN, ANALYSIS AND OPTIMIZATION OF A SMALL UNMANNED AIRCRAFT /
- ANALYSIS OF DESIGN FLAWS IN AN UNMANNED AERIAL VEHICLE (UAV) TARGET DRONE AND FABRICATION, CFD ANALYSIS AND TUNNEL TESTING OF A 3D MODEL POST AMENDMENT /
- DESIGN AND FABRICATION OF A TARGET DRONE /
- SHAPE OPTIMIZATION OF GURNEY FLAP ON AIRFOIL /
- FABRICATION OF AL-6063 METAL MATRIX HYBRID COMPOSITE REINFORCED WITH SIC NANOPARTICALS BY STRI CASTING /
- DESIGN & DEVELOPMENT OF A SOFTWARE TOOL FOR ANALYSIS OF THE CHARACTERISTICS OF INSTRUMENTED RECTILINEAR OPEN LOOP CONTROL SYSTEM /