Ítems similars: A STUDY OF STATIC EXTENDED TRAILING EDGE FOR LIFT ENHANCEMENT /
- CHARACTERISTIC ANALYSIS OF NACA 0018 AND NACA 2412 AIRFOIL WITH LEADING EDGE AND TRAILING EDGE ROTATING CYLINDER /
- EXPERIMENTAL STUDY ON THE EFFECT OF DIFFERENT WINGLET CONFIGURATIONS ON THE LIFT AND DRAG CHARACTERISTICS OF A BLENDED WING BODY AIRCRAFT /
- NUMERICAL INVESTIGATION OF LIFT AUGMENTATION WITH CO-FLOW JET AIRFOIL /
- A NUMERICAL ANALYSIS ON THE AERODYNAMIC CHARACTERISTICS OF NACA 0015 AND NACA 2412 AEROFOILS WITH CURVED TRAILING-EDEG PLANFORM /
- "INFLUENCE OF SURFACE MODIFICATION ON THE LIFT-DRAG CHARACTERISTICS OF NACA 0012 AIRFOIL" /
- LARGE DEFECTION ANALYSIS OF AN AIRCRAFT WING WITH ELLIPTICAL LIFT DISTRIBUTION AT DIFFERENT FLIGHT CONDITION /
Tema: Aeronautical Engineering
- ACTIVE CONTROL OF FLOW PAST OVER NACA 0021 THROUGH LEADING EDGE MOMENTUM INJECTION USING ROTATING CYLINDER: A COMPARATIVE INVESTINGATION BETWEEN NUMERICAL & EXPERIMENTAL ANALYSIS/
- A COMPREHENSIVE STUDY OF FLOW THROUGH CIRCULAR PIPE /
- MODELING AND SIMULATION OF LONGITUDINAL AUTOPILOT FOR GENERAL AVIATION AIRCRAFT /
- DEVELOPMENT OF A PHASED OUT AIRCRAFT AS EDUCATIONAL AID /
- MACHINABILITY OF POLYMER MATRIX COMPOSITES (PMC)-A REVIEW OF CURRENT STATUS AND FUTURE PROSPECTS /
- ANALYSIS AND INSTALLATION OF AVIONICS SYSTEM IN A SMALL UNMANNED AIRCRAFT /
Tema: This Thesis Paper of AE in B.Sc. Program.
- DESIGN, ANALYSIS AND OPTIMIZATION OF A SMALL UNMANNED AIRCRAFT /
- ANALYSIS OF DESIGN FLAWS IN AN UNMANNED AERIAL VEHICLE (UAV) TARGET DRONE AND FABRICATION, CFD ANALYSIS AND TUNNEL TESTING OF A 3D MODEL POST AMENDMENT /
- DESIGN AND FABRICATION OF A TARGET DRONE /
- SHAPE OPTIMIZATION OF GURNEY FLAP ON AIRFOIL /
- FABRICATION OF AL-6063 METAL MATRIX HYBRID COMPOSITE REINFORCED WITH SIC NANOPARTICALS BY STRI CASTING /
- DESIGN & DEVELOPMENT OF A SOFTWARE TOOL FOR ANALYSIS OF THE CHARACTERISTICS OF INSTRUMENTED RECTILINEAR OPEN LOOP CONTROL SYSTEM /