Схожі ресурси: STUDY AND DEVELOPMENT OF MOVING TARGET LOCATION AND RANGE ACQUIRING SYSTEM ALONG WITH GUI TO INCORPORATE IN A PROTOTYPE LOW-COST ACTIVE PHASED ARRAY RADAR /
- STUDY AND DEVELOPMENT OF MOVING TARGET LOCATION AND RANGE ACQUIRING SYSTEM ALONG WITH GUI TO INCORPORATE IN A PROTOTYPE LOW-COST ACTIVE PHASED ARRAY RADAR.
- ANALYSIS OF RADAR SIGNAL USING MICROSTRIP ANTENNA FOR SELECTING OPTIMUM THRESHOLD IN ORDER TO DESIGN & FABRICATE A PROTOTYPE LOW-COST ACTIVE PHASES ARRAY /
- ACQUISITION & ANALYSIS OF TIME DOMAIN RAW DATA TO DEVELOP A GRAPHICAL USER INTERFACE IN ORDER TO DESIGN & FABRICATE A PROTOTYPE LOW-COST ACTIVE PHASED ARRAY RADAR /
- ANALYSIS OF RADAR CROSS SECTION (RCS) OF DIFFERENT SHAPE OF TARGETS USING MICROSTRIP ANTENNA IN ORDER TO DESIGN & FABRICATE A PROTOTYPE OF LOW COST PHASED ARRAY RADAR /
- ANALYSIS OF RADAR CROSS SECTION (RCS) OF DIFFERENT SHAPE OF TARGETS USING MICROSTRIP ANTENNA IN ORDER TO DESIGN & FABRICATE A LOW COST ACTIVE PHASED ARRAY RADAR /
- ACQUISITION & ANALYSIS OF TIME DOMAIN RAW DATA TO DEVELOP A GRAPHICAL USER INTERFACE FOR DESIGNING & FABRICATION OF A PROTOTYPE OF LOW - COST PHASED ARRAY RADAR /
Тема: Aeronautical Engineering
- DESIGN,ANALYSIS AND FABRICATION OF A FULLY ARTICULATED HELICOPTER MAIN ROTOR SYSTEM /
- DETERMINATION OF FLOW CHARACTERISTICS AND PERFORMANCE ANALYSIS OF THE NON-ROTATING & ROTATING CYLINDER /
- DESIGN AND OPTIMIZATION OF LOW SPEED WIND TURBINE WITH MOMENTUM INJECTION /
- STUDY ON MECHANICAL BEHAVIOR OF SISAL AND BANANA FIBER REINFORCED POLYMER MATRIX COMPOSITES /
- A STUDY OF FLOW THROUGH CIRCULAR PIPE /
- EVALUATION OF THE INFLUENCE OF CARBON NANO PARTICLES ON THE MECHANICAL BEHAVIOR OF PARTICLES ON THE MECHANICAL BEHAVIOR OF BANANA FIBER REINFORCED POLYMER COMPOSITE /
Тема: This Thesis Paper of AE in B.Sc. Program.
- DESIGN, ANALYSIS AND OPTIMIZATION OF A SMALL UNMANNED AIRCRAFT /
- ANALYSIS OF DESIGN FLAWS IN AN UNMANNED AERIAL VEHICLE (UAV) TARGET DRONE AND FABRICATION, CFD ANALYSIS AND TUNNEL TESTING OF A 3D MODEL POST AMENDMENT /
- DESIGN AND FABRICATION OF A TARGET DRONE /
- SHAPE OPTIMIZATION OF GURNEY FLAP ON AIRFOIL /
- FABRICATION OF AL-6063 METAL MATRIX HYBRID COMPOSITE REINFORCED WITH SIC NANOPARTICALS BY STRI CASTING /
- DESIGN & DEVELOPMENT OF A SOFTWARE TOOL FOR ANALYSIS OF THE CHARACTERISTICS OF INSTRUMENTED RECTILINEAR OPEN LOOP CONTROL SYSTEM /