Similar Items: SHAPE OPTIMIZATION OF GURNEY FLAP ON AIRFOIL /
- SHAPE OPTIMIZATION OF GURNEY FLAP ON AIRFOIL
- INVESTIGATION OF THE EFFECT OF DIFFERENT AIRFOIL SHAPED FUSELAGE ON THE PERFORMANCE OF AN UNMANNED AIR VEHICLE /
- SURFACE MODIFICATION OF NACA 4418 AIRFOIL WITH DIFFERENT SHAPED DIMPLES AND AERODYNAMIC PERFORMANCE ANALYSIS /
- COMPARATIVE STUDY OF BLOWING AND SUCTION SLOT GEOMETRY OPTIMIZATION ON NACA 0015 AND NACA 2412 AIRFOIL /
- NUMERICAL INVESTIGATION OF LIFT AUGMENTATION WITH CO-FLOW JET AIRFOIL /
- THE EXPERIMENTAL STUDY OF THE AERODYNAMIC CHARACTERISTICS OF THE AIRFOIL OF FOUGA MAGISTER 170 /
Topic: Aeronautical Engineering
- ACTIVE CONTROL OF FLOW PAST OVER NACA 0021 THROUGH LEADING EDGE MOMENTUM INJECTION USING ROTATING CYLINDER: A COMPARATIVE INVESTINGATION BETWEEN NUMERICAL & EXPERIMENTAL ANALYSIS/
- DESIGN AND DEVELOPMENT OF A BLADE ANTENNA FOR AIRCRAFT NAVIGATION AND COMMUNICATION /
- COMPARATIVE STUDY OF SWIRL FLOW & JET FLOW /
- COMPARATIVE STUDY OF AIRCRAFT APPROACH AND LANDING PERFORMANCE USING ILS, MLS AND GLS /
- MANUFACTURE AND MISSION PERFORMANCE ANALYSIS OF SMALL UNMANNED AIRCRAFT’ /
- A COMPARISON OF EXPERIMENTAL WITH SIMULATION EFFECTIVE OF NACA 0012 AIRFOIL WITH BARE /
Topic: This Thesis Paper of AE in B.Sc. Program.
- DESIGN, ANALYSIS AND OPTIMIZATION OF A SMALL UNMANNED AIRCRAFT /
- ANALYSIS OF DESIGN FLAWS IN AN UNMANNED AERIAL VEHICLE (UAV) TARGET DRONE AND FABRICATION, CFD ANALYSIS AND TUNNEL TESTING OF A 3D MODEL POST AMENDMENT /
- DESIGN AND FABRICATION OF A TARGET DRONE /
- SHAPE OPTIMIZATION OF GURNEY FLAP ON AIRFOIL /
- FABRICATION OF AL-6063 METAL MATRIX HYBRID COMPOSITE REINFORCED WITH SIC NANOPARTICALS BY STRI CASTING /
- DESIGN & DEVELOPMENT OF A SOFTWARE TOOL FOR ANALYSIS OF THE CHARACTERISTICS OF INSTRUMENTED RECTILINEAR OPEN LOOP CONTROL SYSTEM /