-
EXPERIMENTAL INVESTIGATION ON THE CHARACTERISTICS OF A CLOSED LOOP PULSATING HEAT PIPE (CLPHP) FOR DIFFERENT FLUIDS
-
HEAT TRANSFER CHARACTERISTICS OF A CLOSED LOOP PULSATING HEAT PIPE WITH FIN AND WIRE INSERT / Lt. Tauhidul Islam, Rasel A Sultan, Noor Mohammad Hasan.
-
EFFECT OF FIN ON THE PERFORMANCE CHARACTERISTICS OF CLOSE AND OPEN LOOP PULSATING HEAT PIPE
-
Performance Comparison of Fluids in a Closed Loop Pulsating Heat Pipe
-
EXPERIMENTAL INVESTIGATION THE PERFORMANCE OF OPEN LOOP PULSATING HEAT PIPE / Halima Khatun Tahmin, Rumana Parvin Rinky, Afrina Khan Piya, Tonima Afrose.
-
EXPERIMENTAL INVESTIGATION INTO THE THERMAL PERFORMANCE OF A CLOSED-LOOP PULSATING HEAT PIPE USING WATER-ETHANOL BINARY MIXTURES FOR ELECTRONICS COOLING /
-
PERFORMANCE ANALYSIS OF A CLOSED-LOOP PULSATING HEAT PIPE FOR ENHANCEMENT OF PHOTOVOLTAIC CELL EFFICIENCY /
-
THE EFFECT OF ETHANOL AS WORKING FLUID ON THE PERFORMANCE OF DIFFERENT TYPES OF CLOSED LOOP PULSATING HEAT PIPE / Mehrin Chowdhury, Sanjida parveen, Nawshad Arslan Islam, Sayed Mahmud Mufti.
-
DESIGN OF A CLOSED LOOP SUBSONIC WIND TUNNEL /
-
HEAT TRANSFER ENHANCEMENT IN A PIPE FLOW USING A ROTATING TWISTED TAPE INSERT
-
PERFORMANCE ANALYSIS OF PULSATING HEAT PIPE INCORPORATED WITH TESLA TYPE D-VALVE
-
PERFORMANCE ANALYSIS OF PULSATING HEAT PIPE INCORPORATED WITH TESLA TYPE D- VALVE /
-
ENHANCEMENT OF HEAT TRANSFER IN A PIPE FLOW USING A SWIRLING PERFORATED TWISTED TAPE INSERT
-
Design And Fabrication Of A Bench Mounted Closed Loop Wind Tunnel
-
DESIGN IMPROVENMENT AND DEVELOPMENT OF A CLOSED LOOP SOLAR HEAT COLLECTOR WITH DATA ACQUISITION SYSTEM /
-
House wiring
-
FLOW CHARACTERISTICS AND HEAT TRANSFER CHARACTERISTICS OVER NACA 4415 AIRFOIL
-
A P-MEDIAN CLOSED LOOP MODEL USING TABU SEARCH FOR HEALTH CARE SUPPLY IN BANGLADESH /
-
COMPARISON OF AERODYNAMIC PROPERTIES OF TRADITIONAL TURBINE BLADES AND CLOSED-LOOP TURBINE BLADES FOR WIND ENERGY EXTRACTION /
-
Electrical wiring, estimating & costing /
-
Electrical wiring, estimating & costing /
-
Electrical Wiring, Estimating & Costing /
-
Electrical Wiring, Estimating & Costing /
-
ENHANCEMENT OF TURBULENT FLOW HEAT TRANSFER IN A CIRCULAR TUBE WITH POROUS DISE INSERTS /
-
MODELING AND SIMULATION OF PRESSURE WAVE PROPAGATION OF AN AUTOMOTIVE EXPLOSION ENGINE MUFFLER USING COMSOL MULTI PHYSICS SOFTWARE /
-
STUDY OF TWO PHASE LOOP THERMOSYPHON BY USING VARIOUS EVAPORATOR SURFACE GEOMETRIES WITH DIFFERENT WORKING FLUIDS /
-
STUDY ON PERFORMANCE CHARACTERISTICS OF CENTRIFUGAL PUMP AND CONSTRUCTION OF AN EXPERIMENTAL SET UP FOR THE STUDY /
-
A STUDY OF BIOMASS BRIQUETTE IN BANGLADESH /
-
A STUDY ON MIRPUR-12 TO ROKEYA SHARANI ROAD WITH SPECIAL EMPHASIS ON PEDESTRIAN SAFETY AND FACILITY /
-
DESIGN AND DEVELOPMENT OF A NOVEL BIODEISEL PROCESSOR AND PERFORMANCE ANALYSIS OF B1OO BIO DIESEL PRODUCED FROM SOYBEAN OIL / Md.Shihab Uddin, Sarjil Mehedi, M A.Masum Bulbul Chowdhwary.
-
DESIGN AND FABRICATION OF A VAPOR ABSORPTION REFRIGERATION SYSTEM / Mosharrouf Hossain, S.M Rafid Rahman, Saadman Shoumik.
-
STUDY OF SMALL AND MEDIUM ENTERPRISES (SME) PRODUCTS IN BANGLADESH: PERFORMANCE AND QUALITY IMPROVEMENT OF A SELECTED PRODUCT / Muksadur Rahman, Md Nazrul Huda Aslam, Jakia sultana.
-
A COMPARATIVE STUDY ON EMISSION OF GASOLINE AND NATURAL GAS DRIVEN VEHICLE ALONG WITH ITS EFFECT ON ENVIRONMENT AND HEALTH ISSUES / Capt Md. Rashedul Islam Lt. Most Irana Yeasmin, Khalid Bin Md Kamruzzaman, Zawad Abedin .
-
ONE DIMENSIONAL FLOW THROUGH PIPE / Md. Shakib Mamud, Md. Faisal Hasan, Kazi Abdul Al Moin Rumu.S M Mahid.
-
STUDY OF A SELF MADE BIOMASS STOVE AND ELECTRICITY GENERATOR FROM WASTE HEAT USING THERMOELECTRIC GENERATOR / Md. Mominul Haque, Md. Mahmoodul Haque, Imteaz Osmani, Md. Asad Hossain .
-
Fabrication & Performance Test Of A High Temperature Differential Stirling Engine /
-
PERFORMANCE EVALUATION OF 1.68 KWP DC-OPERATED SOLAR PUMP WITH AUTO TRACKERS USING MICRO CONTROLLER BASED DATA AC ACQUISITION SYSTEM /
-
THE COST OF EMISSION AND EXCESS FUEL CONSUMPTION FROM THE AUTOMOTIVE VEHICLES IN DHAKA CITY /
-
STUDY AND DETERMINATION OF THERMAL CONTACT CONDUCTANCE /
-
DESIGN OPTIMIZATION OF WORM GEAR /
-
BIOMASS BRIQUETTE –AN ALTERNATIVE SOURCE OF ENERGY IN BANGLADESH /
-
DESIGN AND CONSTRUCTION OF A MECHANICAL MOTION RECTIFIER (MMR) /
-
DESIGN IMPROVENMENT AND DEVELOPMENT OF A CLOSED LOOP SOLAR HEAT COLLECTOR WITH DATA ACQUISITION SYSTEM /
-
OIL GAS TRANSPORTATION FROM OFF SHORE TO ON SHARE CFD APPROACH /
-
DESIGN & CONSTRUCTION OF A SPEED BUMP ENERGY GENERATOR /
-
PERFORMANCE ANALYSIS OF LUBRICANT FOR AUTOMOBILE ENGINES BY CONDITION MONITORING /
-
DESIGN AND DEVELOPMENT OF A COMPACT SPIRAL COIL HEAT EXCHANGE AND COMPARATIVE ANALYSIS OF ITS PERFORMANCE /
-
AUDIT AND MAINTENANCE INSPECTION OF ELEVATORS IN BANGLADESH /